|
|
#1
02-27-2012, 02:29 PM
|
||||
|
||||
|
Seat Creases
Just wondering if there is a way to remove the seat creases. My LX sport has creases mainly on the driver side on the seat bottom part closest to the door. Look for some tips and tricks from the experts here. I use Zaino leather in a bottle to condition them. They look good minus the creases.
Thanks.
__________________
2004 Ford Crown Victoria LX Sport Mods: 21mm rear sway bar, Marauder head unit, Marauder sub/amp, Curless cure. 2012 Chevrolet Caprice PPV 2008 Ford Crown Victoria Police Interceptor (Rest in peace my friend, we had a good run.) Hg = Mercury (see periodic table of elements). 
|
|
#2
02-27-2012, 03:45 PM
|
||||
|
||||
|
Easy...don't sit in it.lol
__________________
 13's I can smell you.
|
|
#3
02-27-2012, 06:55 PM
|
||||
|
||||
|
Short of reupholstering, don't think you can remove creases from the seats.
__________________
 2003 300B DBP Build date: 6/19/03 Number 7,792 of 7,838 - 326 of 328 Proud member of the MM "BLUES" Bros. Purchased: 11/10/05 Eaton swap by ImpalaSlayer 11-09-10 Semper et in Aeternum, Mercurius. In Memory: 2004 DTR Build Date 01/27/04 Purchased 04/04/04 Wrecked 10/19/05, R.I.P. 
|
|
#4
02-27-2012, 08:22 PM
|
||||
|
||||
|
Find a way and become RICH!
__________________
 Mods: Mr. Norm's Garage Custom Dyno Tune, Stainless Works Headers with High Flow Cats, Stainless Works Full Exhaust System with X Pipe, High Performance Trans Rebuild Kit, LPD 40,000 GVW Trans Cooler, B & M Deep Trans Pan, Forced Lube Mod, Metco Control Arms, Police MMX Driveshaft, Ford Racing 4.10's, Ford Racing Carbon Trac-Lok Clutches, Ford Racing Axle Girdle, JLT Cold Air Kit, Steeda Pulleys, Accel Super Coils, 180 Stat, Walbro 255lph Fuel Pump, Custom JustBob Hood, Powered by Ford COP Covers, Slotted/Drilled Rotors, Wagner Thermoquiet Ceramic Pads, Monroe Gas-Magnum Shocks and Struts, Dead Pedal, SRP Racing Pedals, 25% Tints, Rear Spoiler, Pioneer Avic 940 Nav Stereo and a whole lot of  !!!
|
|
#5
02-27-2012, 09:02 PM
|
||||
|
||||
|
__________________
The Dude "By the way, do you think that you could give me that $20,000 in cash? My concern is, and I have to, uh, check with my accountant, that this might bump me into a higher, uh, tax..." Dude-ism - "Put yourself on the Ignore List and don't worry about it". Dictator - "We cannot continue to rely on our military in order to achieve the national security objectives that we've set. We've got to have a civilian national security force that's just as powerful, just as strong, just as well-funded."
|
|
#6
02-27-2012, 09:45 PM
|
||||
|
||||
|
Leather conditioner well help prevent creases but you probably can't get rid of them...ever.
__________________
┼∞█The Black Bomber█∞┼  Aftermarket Sun Roof, Spoiler and Heated Seats, BC4E Dead Pedal PERFORMANCE - ADCO Front and Rear Sway Bars, K&N FIPK Air Intake, XCal2 Tuned by DR LIGHTS - 4500KHID Headlights, True 3000K Osram Foglights SOUND SYSTEM - Infinity Reference Speakers All Around, Infinity Reference 4 Channel 465W AMP, 2 10" Audiobahn Subs in Enclosed/ported box APPEARANCE - Tints w/Windshield Eyelid, SS Inserts, S55 Tail Light Treatment, Full Interior LED Upgrade w/Guages and Cluster, CMS Gods Head Conversion, Custom Floor Mats From CarMotorsports Ordered and Awaiting Arrival. Satin Pedals (Can't Wait!) (IT'S TAX SEASON, ENJOY YOURSELF!!!) 
|
|
#7
02-27-2012, 10:59 PM
|
|||
|
|||
|
Contact Roger Koh at LeatherDoctor.com, I talked to him about this for a while and he swears it will work and is known on the detail forums, but its not gonna be a $10 bottle of conditioner so prepare yourself to sink some money in.
__________________
Black 2003 300A Marauder Build Date 06-02 84K Miles Bought used 05/07/11 Slowly Restoring 00 White CVPI (KTA Car)
|
|
#8
02-28-2012, 05:47 AM
|
||||
|
||||
|
They aren't creases, it's called "patina"
__________________
 Wanna sell your Twin Screw? Trilogy #36 #2529 of 7839 See Garage for mods. O bsessive C ar D etailer 1965 25 Bertram Custom CC with tower Custom bracket 28 MPH @ 3.5 MPG Top speed 42 MPH W/single 225 Merc Optimax
|
|
#9
02-28-2012, 06:40 AM
|
||||
|
||||
|
I have used these products, and they worked well on the cracks in my old Volvo and BMW. Very time consuming, but results were impressive. I don't know how they would work on American car leather, as I have only used them on Foreign cars.
OZ http://www.leatherique.com/
__________________
If everything seems to be in control, you're not going fast enough. - Mario Andretti  2003 (300B) Build Date: 01/07/03 Delivered: 07/14/03 @ Crossroads Ford Lincoln Mercury Frankfort, Kentucky Adopted: 11/23/09 in Missouri #6483 of 7838 Black/ Light Flint (1 of 115) Original Stock
|
|
#10
02-28-2012, 08:45 AM
|
|||
|
|||
|
I use leatherique on mine and IMO it is no better than an OTC on my MM or on my 4runner. I don't know if the MM leather is clear coated, if so that will make a big difference in ease of removal.
__________________
Black 2003 300A Marauder Build Date 06-02 84K Miles Bought used 05/07/11 Slowly Restoring 00 White CVPI (KTA Car)
|
|
#11
02-28-2012, 08:48 AM
|
||||
|
||||
|
Pretty sure they are coated.
__________________
FIT/ProCharger Racing Team Member #007 PROCHARGER SUPERCHARGER FROM F.I.T. # 007 12psi MMR built Stroker 5.0+.020 overbore Forged Crank/Manley Rods/Manley Pistons Billet Oil Pump ARP Bolts and head studs Snow Methanol Injection 3500 Stall Converter (PI) Stryker 340 E85 Fuel Pump 60 PSI Injectors 4:10 gears K&N Air Filter Factory Spoiler Widened Wheels Nittos 180 deg thermostat SS Inserts Daniel's Colex Billet Supercharged Emblems front and rear
|
|
#12
02-28-2012, 09:18 AM
|
||||
|
||||
|
The leather is creasing as the cushion underneath is worn/squished. If you were to add to the material under the leather cover it would tighten and remove some of the crease.
__________________
03 300A - #1727 ! - 13.9 @ 99 N/A- FRPP 3.73s -23mpg @ 80 - Trick Flow Girdle - FRPP CF clutches, Reinhart Rear Head Cooling Kit! - Reische 170 stat - EMP Stewart Pump - Police MMC Shaft - PML Deep pan - Granetelli Ropes - SG II - 30 LEDFed Sig CHMSL - KarKraft spacer - 9.5" PI 3000 Triple TC - Factory remote start +keyless - Accufab twin 60mm tbody - 24K Long Mini Max Trans Cooler - JMOD - ADTR Heinous Billet Rear Control Arms - 2.25" Stainless Mandrel mids - Magnaflow Muffled X Pipe - Ceramic P&P Upper - Stainless Works Longtubes 3" cats - Kinsler fuel filter - Fitch Fuel Catalyst - BOC 255lph fuel pump - Escape Audiophile - BC4E Dead Pedal - Proguard + Sag Fix - Fastblack Merc HD LCM & LED Kit - Nitto 555 265-50-18 - Moog front end - SS TCE Lines - NA SVT P&P Lower - DBA4000 Rotors & Hawk HPS from KNS - March 1158 Fluid Filled Underdrives -PHP CAI with Metco Carbon Fiber Intake tube.
|
|
#13
02-28-2012, 03:56 PM
|
||||
|
||||
|
Normal wear and tear....nothing last forever but we all want the best for Rauders!
|
|
#14
02-29-2012, 01:15 PM
|
||||
|
||||
|
Thanks for all the replies, especially the helpful ones.
 The leatherdoctor site is down I'll check on that later. Interesting note about the cushions. I know for the CVPI there is a seat repair kit that includes a new bottom cushion but that is for '02-. Anyone know of such a kit for the '03+?
__________________
2004 Ford Crown Victoria LX Sport Mods: 21mm rear sway bar, Marauder head unit, Marauder sub/amp, Curless cure. 2012 Chevrolet Caprice PPV 2008 Ford Crown Victoria Police Interceptor (Rest in peace my friend, we had a good run.) Hg = Mercury (see periodic table of elements).
|
|
#15
02-29-2012, 07:05 PM
|
||||
|
||||
|
Quote:
__________________
03 300A - #1727 ! - 13.9 @ 99 N/A- FRPP 3.73s -23mpg @ 80 - Trick Flow Girdle - FRPP CF clutches, Reinhart Rear Head Cooling Kit! - Reische 170 stat - EMP Stewart Pump - Police MMC Shaft - PML Deep pan - Granetelli Ropes - SG II - 30 LEDFed Sig CHMSL - KarKraft spacer - 9.5" PI 3000 Triple TC - Factory remote start +keyless - Accufab twin 60mm tbody - 24K Long Mini Max Trans Cooler - JMOD - ADTR Heinous Billet Rear Control Arms - 2.25" Stainless Mandrel mids - Magnaflow Muffled X Pipe - Ceramic P&P Upper - Stainless Works Longtubes 3" cats - Kinsler fuel filter - Fitch Fuel Catalyst - BOC 255lph fuel pump - Escape Audiophile - BC4E Dead Pedal - Proguard + Sag Fix - Fastblack Merc HD LCM & LED Kit - Nitto 555 265-50-18 - Moog front end - SS TCE Lines - NA SVT P&P Lower - DBA4000 Rotors & Hawk HPS from KNS - March 1158 Fluid Filled Underdrives -PHP CAI with Metco Carbon Fiber Intake tube.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seat cleaner to beat all seat cleaners! | CBT | Community Discussion | 40 | 08-26-2010 10:37 AM |
| I need help with my seat | Motorhead350 | The Lounge | 5 | 06-26-2008 06:21 PM |
| Seat flap hangs down in front of seat | Architect | Shop Talk | 11 | 10-30-2007 02:17 PM |
| Car Seat for a MM?? Who looking? | Badger | Community Discussion | 0 | 09-21-2005 05:58 PM |
| Seat Covers | Dan | The Lounge | 6 | 08-08-2004 05:14 PM |
Linear Mode
