rear seat removal

[88LTDCV351]

Does the Marauder rear seat remove the same way as older Crown Vics?

I want to finally put the seat covers from seatcoversunlimited on properly. And I know from my 30 year old Vic that the bottom just pops out and the back has some starbit bolts near the bottom edge but the top just pops out. Have also seen from pick n pull how easy it is to warp the seat foam by pulling it out too hard.

I tried first to pull the Marauder rear seat bottom out but pulling without too much force, it hasn't popped out yet. Didn't want to apply too much force. You have to remove the bottom to access the screws for the seat back, right?

[offroadkarter]

Bottom seat pulls up and out, if yours has never been out you'll have to pull really hard.

[03Merc]

You can pull it up front the front to pop it out, to get it back in You have to push it back and down till it latches. You'll see the hooks when You pop it up. Then You'll see the seatbelt bolts holding down the back part. You lift that up as well.


Sent from my iPhone using Tapatalk Pro

[justbob]

From what I remember push in (pushing the bottom towards the rear), then up.


Sent from my iPhone using Tapatalk Pro

[Spectragod]

Push back and pull up for the bottom cushion, the seat back has 2 18mm nuts holding it at the belt attachment point on the floor


Sent from my iPhone using Tapatalk