PDA

View Full Version : Best way to change Oil Pan?



jaywish
08-21-2019, 10:10 AM
Yup I made a rookie mistake and crushed the front of the oil pan. It must be replaced. Was floor jacking it in preparation to inserting jack stands. Have not had a floor jack slip since I was 19. A long long time ago.

Looking at it I think it might be easier doing it from the bottom after removing the crossmember?

From the top or bottom?

I don't have an engine crane anymore so if the crossmember must come out I must support the engine. Some wood and chain to hold the engine up? I didn't see any lift ears? Worth buying an engine support tool? Suggestions?

Just use a new Fomco gasket or a better one? No leaks on the Fomoco yet.

Jay

Comin' in Hot
08-21-2019, 04:27 PM
Pulling the engine is the easiest way. Not sure about removing the crossmember.

musclemerc
08-21-2019, 05:20 PM
I forget the name of the bracket but it secures from the lip on both fenders and supports the weight of the engine so the K member can be removed.

Surely someone else has seen one.

blazen71
08-22-2019, 06:11 AM
I forget the name of the bracket but it secures from the lip on both fenders and supports the weight of the engine so the K member can be removed.

Surely someone else has seen one.

https://www.harborfreight.com/1000-lb-capacity-engine-support-bar-96524.html

musclemerc
08-22-2019, 06:40 AM
That's the part....

jaywish
08-22-2019, 01:21 PM
Yup just ordered a tripod type.

Guess I am going in through through the bottom.

ordered a ford pan & Gasket from Tasca

musclemerc
08-22-2019, 02:52 PM
You were able to find an OEM pan? I thought they were long gone.

jaywish
08-22-2019, 03:51 PM
Well Tasca showed it available. So far no cancellation notice.

Zack
08-23-2019, 09:28 AM
Weld a hook to the pan and use a slide hammer to fix it.

jaywish
08-23-2019, 10:37 AM
Zack, That is probably the easiest method by far. And if I Burned a hole in it I would be no worse off.

The oil pickup tube runs to the front of the engine? I am concerned I may have bent that.

Also need to decide if having a nice looking pan under there would make a difference when the time comes to finally sell it. Car has 36K on it now and is still pretty nice as it sees no salt and usually stays inside during rain.

Of course I paid for expedited shipping on everything so I could get this done then it turns out I am in rapid Afib. I knew something was wrong but could not figure out what. This is why I dropped the car along with several other much smaller things and a few minor bits of damage to the Mercedes. Weird experience. So no hard work for the for near future till I am back in rhythm however long that takes. Maybe a week or so? We will see.

Agent2006
08-23-2019, 11:49 AM
good luck Jay, my FIL had some bad AFib and turns out his potassium got way low.