Mods before or after?

[Tallboy]

OK, Trilogy guys-I've made up my mind on a couple things I was thinking about. But, as usual, I want your input. For those of you with the Trilogy kit and other mods I want to know if you did the additional mods before or after you installed the blower.

Thanks in advance...:beer:

[Deebar]

Trilogy sc first, then Nittos w/DRs and 4.10s. Phase 3 was better breathing with Kooks long tubes, custom 2 1/2 inch exhaust, JLT intake and 2.8 pulley. 500 miles later MMX drive shaft rear end girdle and stud kit. Next up- fuel pump upgrade, big brakes (Jerry?!?) and possibly an accufab TB.

[Cobra25]

OK, Trilogy guys-I've made up my mind on a couple things I was thinking about. But, as usual, I want your input. For those of you with the Trilogy kit and other mods I want to know if you did the additional mods before or after you installed the blower.

Thanks in advance...:beer:
Did most of the mods before the S/C with the exception of the K&N Air Charger Kit & the DiabloSport Mafia -MAF extender.

[Tallboy]

Did most of the mods before the S/C with the exception of the K&N Air Charger Kit & the DiabloSport Mafia -MAF extender.Z, thanks again for letting me drive your car! Your car is the reason I'm going with the K&N and the 10.5 PSI pulley.:up:

[MARAUDER S/C #5]

After...............

[Roger D]

4.10's and bigger rims simultaneously during the s/c install before the car was registered - swaybar after, kooks, intake, speakers and lights to come.


Roger D

[BillyGman]

Everything was before the S/Cer except the Nitto drag radials. I never had any need for drag radials until I S/Ced the car.

[Cobra25]

Z, thanks again for letting me drive your car! Your car is the reason I'm going with the K&N and the 10.5 PSI pulley.:up: You might want if you get the 10.5 pully to change the belt so it's not at the end of the tensioner. The new Belt # NAPA 25- 080505. Cost $26.99. You will need a second hand getting it on.

[bigslim]

Had the 410's and the K&N before the kit.