kirk
12-19-2005, 08:23 PM
My daughter has a 1987 Topaz with the 2.3 CFI that has been running ruff and stalling out. I did a visual inspection and then ran a quick test. I got a 78 from key-on engine-off, and a 21 & 52 from the engine-on. Code 21 has you check the TPS and ECT. If these check out OK (which they did) then repace the processor.
I cleared the codes and tried several more times between investigations. I consistantly got 21, 52, and then 99. On the last run I got a 15 (replace processor) in the engine-off quick test.
I do not have a breakout box so I can't say the harness is good. I was going to pull the processor connection and see if it is clean, but I can't find it. Anyone know where this processor is? Should I replace the processor or investigate further?
I cleared the codes and tried several more times between investigations. I consistantly got 21, 52, and then 99. On the last run I got a 15 (replace processor) in the engine-off quick test.
I do not have a breakout box so I can't say the harness is good. I was going to pull the processor connection and see if it is clean, but I can't find it. Anyone know where this processor is? Should I replace the processor or investigate further?