Donny Carlson
12-24-2005, 07:30 PM
I was going over the bottom of my SSR last week on the lift and noticed the lower control ares are made out of tubular steel that looks A LOT like a certain aftermarket set of control arms of lore on here. Then, up on the SSR board comes this post about a new set of uppers and lowers being available, including an adjustible pair of lowers.... and the feeling I had looking at them was "hmmm, looks like M&Z did have somthing going here..."
These are new upper and lower tubular control arms for the SSR, the middle set are adjustable so you can dial in a correction for pinion angle. These have lube points and use rubber bushings. Look familar?
http://www.bmrfabrication.com/controlarms/SSR-small.jpg (http://www.bmrfabrication.com/controlarms/SSR.jpg)
http://www.bmrfabrication.com/SSR.htm
These are new upper and lower tubular control arms for the SSR, the middle set are adjustable so you can dial in a correction for pinion angle. These have lube points and use rubber bushings. Look familar?
http://www.bmrfabrication.com/controlarms/SSR-small.jpg (http://www.bmrfabrication.com/controlarms/SSR.jpg)
http://www.bmrfabrication.com/SSR.htm