PDA

View Full Version : RWHP Calculator



Tallboy
01-27-2006, 07:13 PM
Kinda neat. Plug your 1/4 mile numbers in [for those of you that have actually raced your car] and your car's weight and it gives you a RWHP figure.

http://www.s-series.org/htm/calc/hpcalc.htm

HwyCruiser
01-27-2006, 07:53 PM
Excluding driver weight :o it's pretty darn close. 454 rwph from ET and 457 from mph. To show my idiocy, what's brake hp?

Joe Walsh
01-27-2006, 08:03 PM
The HP it gives me is a bunch more than I've dynoed....347rwhp vs 317rwhp dyno
What weight have you plugged in...4400lbs?, 4500lbs?

Maybe I'm very good at the drag strip....;)

Bluerauder
01-27-2006, 08:14 PM
The HP it gives me is a bunch more than I've dynoed....347rwhp vs 317rwhp dyno
What weight have you plugged in...4400lbs?, 4500lbs?

Maybe I'm very good at the drag strip....;)
Oughta be about 4339 lbs for your skinny a$$, Joe. (4164 + 175 ??) ;) :rofl: J/K

Joe Walsh
01-27-2006, 08:16 PM
Oughta be about 4339 lbs for your skinny a$$, Joe. (4164 + 175 ??) ;) :rofl: J/K

HEY! I've been drinking Stouts and Porters and have 'beefed up' to 190 Lbs!!:D

HwyCruiser
01-27-2006, 08:16 PM
I used 4200 lbs. i gain 30 rwhp when I get in it though. :D

TripleTransAm
01-27-2006, 09:55 PM
370 rear wheel horsepower for my LS1's 107.6 mph trap speed? I don't think so...

(dyno'ed at 310 rear wheel hp)

The spread between the ET-based rwhp and the MPH-based rwhp for my particular car shows it's not suited to today's modern motors (with torque curves slightly different than pre-90s motors).

Mike M
01-27-2006, 11:08 PM
Right on the money for my car, it says 419 RWHP and I just recently dynoed it at 412.

I checked my Camaro's numbers and it was very close as well, 748 engine HP.

Tallboy
01-28-2006, 07:03 AM
Excluding driver weight :o it's pretty darn close. 454 rwph from ET and 457 from mph. To show my idiocy, what's brake hp?

Brake Hp is measured at the crankshaft.

Hotrauder
01-28-2006, 10:33 AM
Brake Hp is measured at the crankshaft.

Damn, that Logan is right about that Tallboy! Dennis:D

Smokie
01-28-2006, 10:47 AM
Pretty exact based on ET, 400 rwhp. Way off base on trap speed, 439 rwhp.

HwyCruiser
01-28-2006, 12:54 PM
Brake Hp is measured at the crankshaft.

Since the calculator put mine at 545-548 hp at the crank, it must figure in about 17% power train loss. Is that pretty typical for an automatic transmission?

Tallboy
01-28-2006, 01:14 PM
Since the calculator put mine at 545-548 hp at the crank, it must figure in about 17% power train loss. Is that pretty typical for an automatic transmission?

Yep. I usually figure our drivetrain eats up about 20%.

merc6
01-28-2006, 01:18 PM
BHP is what sells cars ;)