Low Backside

[Dragcity]

I have a question.....

Is there an adjustment for the ride height for the automatic leveling system?

My backside seems to be pretty low these days.

The pump does work, and the system is ON. I believe all is working properly, just want it a little higher in the back.

[KillJoy]

Yup. There is a little slider bar on the Axle on the Driver's Side. It is just in front of the Gas Tank.

Move it LEFT to lower, Right to raise.

I hope this helps.

KillJoy

[Dragcity]

Sweet, Thanks Bro.

[Haggis]

Yup. There is a little slider bar on the Axle on the Driver's Side. It is just in front of the Gas Tank.

Move it LEFT to lower, Right to raise.

I hope this helps.

KillJoy

You mean the Watts Link, right!

[KillJoy]

You mean the Watts Link, right!

I do not think so.

KillJoy

[Bradley G]

Yes, the adjustment slide is a 8 & 10 mm bolt(s) on the drivers side Watts Link arm.

[KillJoy]

Yes, the adjustment slide is a 8 & 10 mm bolt(s) on the drivers side Watts Link arm.

I dis not know it was connect to the Watts Link. I just knew it adjusted the rear ride heigth :D

KillJoy

[Bradley G]

Well , you got the adjustment directions correct!
Right?:P
I dis not know it was connect to the Watts Link. I just knew it adjusted the rear ride heigth :D

KillJoy

[KillJoy]

Well , you got the adjustment directions correct!
Right?:P


No....left :D

KillJoy

[Dragcity]

No, Right. I want it higher...

Whatts the watts link?

Ho's on First?

[KillJoy]

No, Right. I want it higher...

Whatts the watts link?

Ho's on First?

That's what I said.... Right?

;)

This can go on for days :D

KillJoy

PS - Watts Link (http://jlttruecoldair.com/zencart/index.php?main_page=product_in fo&products_id=67)

[magindat]

Good pic, Steve.

The pic is of aftermarket, but you'll get the idea. The yellow part on the pic connects to the pumpkin (rear gear housing) the two ends connect to the car. It's job is to keep the axle centered throughout the suspension travel. The little black thing on the right arm is where the adjustment would be for the height. On a stock link, it's just a slot cut in the stamped arm.

Now, go lay under your car and move the adjustment. Turn the key on, sit on the trunk ledge (trunk open) let it rise. Jump off, turn the key off. Let it level. Welcome to your new height. No likey? Do it again.

[Dragcity]

Sounds too easy to be true...


And here I though I would have to pay my dealer $129.95 to do this.....


I think they lowered it on me on my last visit.

[Marauderjack]

Joe....

I hope you don't have "SPOOKS" in your air suspension like I have!!:mad2:

Every now and then it just "SQUATS" and rides like a damn buckboard!!!:argue:

Next day it's back to normal?? :cool:

It has been better since I put Brian's module in....might have fixed it??:bows:

Marauderjack:D

[MdnightMarauder]

Do you need it on the ground or in the air? Also do you need to have the compressor switch turned off?

[natacop]

to answer ur^ ?
I have a question.....

Is there an adjustment for the ride height for the automatic leveling system?

My backside seems to be pretty low these days.

The pump does work, and the system is ON. I believe all is working properly, just want it a little higher in the back.

[magindat]

Do you need it on the ground or in the air? Also do you need to have the compressor switch turned off?

On level ground. System on.

[MdnightMarauder]

On level ground. System on.
thanks:beer:

[whoskal]

Won't raising the ass end up cause more wear on the front tire's???