PDA

View Full Version : Used driveshaft yokes wanted -- both trans end and pinion end


Stranger in the Black Sedan
10-02-2007, 02:47 PM
Hi guys, I am looking for a nice used set of yokes to use for building a custom Marauder driveshaft. I assume they would be the same yokes from a regular crown vic. PM me please if you have a set!! I don't want to start parting out my good original driveshaft in case I want to do something else with it.
Serge
10-04-2007, 09:23 AM
Are the ones from steel shaft the same? Is so, I have them.
Stranger in the Black Sedan
10-04-2007, 09:54 AM
Serge, I think so. PM me w/ pricing please
Stranger in the Black Sedan
10-15-2007, 12:49 PM
I still need these yokes!!! I just found out that the older generation crown vic/ marquis only used the same size U joints as the Marauder if it had a police or trailer towing option.
bugsys03
10-15-2007, 04:19 PM
I have the yokes. They are still attached to the original MM shaft though. Make me an offer if this is what you need.
Stranger in the Black Sedan
10-29-2007, 11:20 AM
One mo' time! I still need the front and rear driveshaft yokes, from an MM shaft, or from a later model crown vic/marquis shaft. If you have a mids 90s and up steel marquis and crown vic shaft, it should use the same U joints and yokes that the MM shaft does, I checked some parts books. I think pre 92 or 93 got smaller yokes on the steel shafts, but after that they were the same, regardless of steel/police/aluminum or not.

Thanks!!
fastblackmerc
10-29-2007, 11:38 AM
Have you checked recycling yards in your area?
Stranger in the Black Sedan
10-29-2007, 11:45 AM
I don't really have time to be digging through junkyards. I wish I did, because I know the CVPIs turn up all the time. I can buy a CVPI driveshaft whole from a yard if I absolutely have to, I suppose.
Pops
10-29-2007, 12:19 PM
I have the drive shaft left from when we built the GM. If the yokes work 20.00 plus UPS.
Stranger in the Black Sedan
10-31-2007, 02:29 PM
Still need them -- I am having bad luck w/ people getting back to me on the yokes!!
Stranger in the Black Sedan
11-05-2007, 07:58 AM
Bump, I have a rear swivel yoke but I still need the front slip yoke from a used CV/GM/MM driveshaft.
Stranger in the Black Sedan
12-03-2007, 02:54 PM
This post can be deleted, I found the driveshaft parts
Serge
12-03-2007, 03:40 PM
I still have mine. Was waiting for you to get back to me with a measurements but I guess you found them elsewhere.