PDA

View Full Version : ECM Reboot ?



MENINBLK
10-26-2007, 09:57 AM
Is it me or has this happened to anyone else ???

I was driving on the highway yesterday.
Nothing special, and I wasn't kicking the Marauder hard.

I got off an exit ramp and halfway down the ramp the CEL comes on.
I was coasting at about 40 mph.
About a second later the CEL light goes out.
The engine stalled, the Traction Control light came on for a second and went out.
The LOW FUEL light came on and went out after a second.
My speedometer needle starting bouncing between 20 and 40 MPH.

I dropped it into NEUTRAL and tried to start it and nothing happened.
I didnt' even get a starter click. I tried it again and still nothing.
All the time, I was driving with my headlights on and the dash lights never blinked once.

As I slowed to a crawl, I tried the start the Marauder again
and it fired up as if nothing happened.
I put it back into Drive and drove off.
The locks cycled to lock the doors and everything has worked fine.

The time span of all of this ? Maybe 30 seconds.

One thing I want to note is that my turn signals have not been canceling
for the last week or so.
I may need to have the Multifunction switch replaced.
I don't think the switch has any bearing on what happened.

Was I hit by an EMP ?
Did I pass through a wormhole ?
Did a rift open on the exit ramp ?

I dont' know where to begin to look for what could have caused this problem.
My battery is only a little more than a year old.
The Marauder has just turned 80,000 miles, and I think I have released
'the end of the Emissions Warranty' Gremlins...

Blackened300a
10-26-2007, 11:18 AM
It has been rainy here in NY, were you hit by Lightning? lol

Maybe whatever that is effecting your signal switch is rubbing wires.

ckadiddle
10-26-2007, 12:32 PM
An ailen craft was flying low overhead and the Reverse Krendelbrot Multiple Ion Drive they use scrambled your electronics temporarily.

rumble
10-26-2007, 07:16 PM
You have a 300 A, check your wiring harness behind both cylinder heads and next to the wiper motor.

Known problem. Do a search for "harness"

Lots of info here on it.

Good luck!!

rayjay
10-27-2007, 02:51 AM
Were you low on gas and going around a banked curve on the off ramp?

OneBADLsE
10-27-2007, 06:01 AM
Very odd...i'll be watching this one

MERCMAN
10-27-2007, 08:13 AM
You have a 300 A, check your wiring harness behind both cylinder heads and next to the wiper motor.

Known problem. Do a search for "harness"

Lots of info here on it.

Good luck!!


Ditto, one of our older members(tripletransam) had the same symptoms with the cause being the wiring harness