pete
10-03-2003, 05:45 AM
Yesterday I treied out my new chip from Dennis. My Maurader has 21k miles and I've had it for 14 mos. I think my PCM is slightly different as I only had 4 torqs screws holding the circuit board to one of the panels of the PCM housing. After unscrewing them, the board would not come off of the housing, and I couldn't clean off the coating off of one side of the connectors. Still wanting to put the chip in, I slid it on, and started the Marauder. Needless to say there were some computer problems...i.e. the speedometer maxed oput at 140mph and stayed there standing still, shift problems, and the odometer would spin like a clock as if it was going 140mph.
Do any of you local guys know a good area speedshop that would put my chip in the Macomb/Oakland county areas.
My 4.10 gear was going to be installed today by ring and pinion at 15 and Groesbeck, but I'm holding off until the chip is in successfully.
Any input is greatly appreciated.
'03 Maurader
Tinted windows
K & N Air Filter
escort radar
Do any of you local guys know a good area speedshop that would put my chip in the Macomb/Oakland county areas.
My 4.10 gear was going to be installed today by ring and pinion at 15 and Groesbeck, but I'm holding off until the chip is in successfully.
Any input is greatly appreciated.
'03 Maurader
Tinted windows
K & N Air Filter
escort radar