PDA

View Full Version : $500.00 dollar Mustang GT



KNIGHTRIDER
07-29-2009, 06:21 PM
so i have the opurtunity to purchase a 96 mustang gt with a 101k miles on it. some one from work just bought a 2010 mustang gt. now she has her old one and said she will sell it to me for $500. I could park my MM and use this a daily drive. BUT it needs a clutch and after i ran a code reader and came back with/// Manufacture control,Auxilary emmisions control and cilinder 4 missfire. what could they be???????

fastblackmerc
07-29-2009, 06:29 PM
so i have the opurtunity to purchase a 96 mustang gt with a 101k miles on it. some one from work just bought a 2010 mustang gt. now she has her old one and said she will sell it to me for $500. I could park my MM and use this a daily drive. BUT it needs a clutch and after i ran a code reader and came back with/// Manufacture control,Auxilary emmisions control and cilinder 4 missfire. what could they be???????

There is this thing called google. You can "google" the code(s) you read and possible fixes. I just did that for my sons Ford Ranger. He was getting P0305 & P0306 codes.

stangracr
07-29-2009, 07:07 PM
Just let me know where the car is and I will come running with the $500.00 in cash.



ed

juno
07-30-2009, 04:54 AM
Could be a bad ECU/PCM, could be an injector/plug wires/plug.
Unless the body is total junk, buy it before she changes her mind.
What color is it?

RoyLPita
07-30-2009, 05:56 AM
Could be a bad ECU/PCM, could be an injector/plug wires/plug.
Unless the body is total junk, buy it before she changes her mind.
What color is it?

96 GT has wires. I know this because my 97 Town Car is going through them.

Check to see if the intake has been replaced. I replaced the TC one because it broke at the rear heater hose pipe and took out #3 and #4 wires. As for clutches, See if there is anything left by pulling up on the clutch pedal. If not, then the sky is the limit when it comes to selection. However, do your self a favor and buy all you need in one shot (clutch disc, pressure plate, throw out bearing and pilot bearing).

KillJoy
07-30-2009, 07:02 AM
You would be a fool to pass this up....

KillJoy

KNIGHTRIDER
07-30-2009, 06:19 PM
IT's green the body is solid but will require some TLC on the buffing and waxing. as far as the interior goes the drivers seat shows the wear of 101K miles on. when i do replace the clutch (i will buy the car) i will get a complete matching kit with new fly wheel as well, and the obvious a complete tune up with new wires and hope that solves my problem.

ImpalaSlayer
07-30-2009, 06:25 PM
buy it buy it buy it!

in2deep
07-30-2009, 06:57 PM
Did you buy it?

KNIGHTRIDER
07-31-2009, 05:58 PM
i will be picking it up next wednesday, when i will be off. i will take some picture of it then.

ImpalaSlayer
07-31-2009, 06:00 PM
nice! :beer: