PhastPhil
01-21-2010, 09:16 PM
Today, I installed my new JLT cold air setup that I had gotten for Christmas. This is for my 2004 CV Sport. It was spa day for my car today. I took it to my friend's auto body shop so that I could work in warmth. I changed the oil, replaced the brake pads on all four corners, and installed my new JLT. I also reconnected my Scan Guage. On the way home from the shop I made a few stops to run errands, and everything seemed normal according to the Scan Guage. Tonight, on my way to work, I travel my usual 42 mile one way trip into work and the Scan Guage is telling me that I am getting 63.2 miles per gallon, and only used .7 gallons of gas. ! :banana:
Woah ! Call Ford, tell them not to cancel the Panther platform vehicles. We've made an important discovery that will save the company !
Me and JLT are going to be world famous !
Seriously. The only thing I can think of, is that I did not disconnect the car's battery when I installed the JLT. I know that when making changes to the car that can alter the parameters of the performance, that the battery needs to be disconnected to clear out the computer and reset it. But I didn't think the cold air set up would make that much of a difference. So I guess I'll disconnect the battery when I get home from work, and see if that helps.
I did recheck all the setting on my Scan Guage because I recently had it in my wife's minivan. My Scan Guage is usually pretty accurate. All of the other settings seemed to working fine.
Woah ! Call Ford, tell them not to cancel the Panther platform vehicles. We've made an important discovery that will save the company !
Me and JLT are going to be world famous !
Seriously. The only thing I can think of, is that I did not disconnect the car's battery when I installed the JLT. I know that when making changes to the car that can alter the parameters of the performance, that the battery needs to be disconnected to clear out the computer and reset it. But I didn't think the cold air set up would make that much of a difference. So I guess I'll disconnect the battery when I get home from work, and see if that helps.
I did recheck all the setting on my Scan Guage because I recently had it in my wife's minivan. My Scan Guage is usually pretty accurate. All of the other settings seemed to working fine.