I need some quick help with parking lamps!

[Baconbit]

My fuse #21 under the dash blew. Its says in manual it is lcm for park lamps and interior illumination, autolamp/sunload sensor 15a. I put a new one and it blew immediately. No parking lights, but i have interior and headlights? Please help!

[Baconbit]

OK well a split thumb nail and about an hour into it, my dad and I figured out it was a wire in the passenger rear taillight that was rubbed bare. Taped it up and put the light back on and all is well thank god.:beer:

[screamn]

Just wondering how this wire rubbed bare?

Did you do something to the tail light recently....change a bulb???

Glad you found the problem..

[Baconbit]

Yea I installed a sequntial turn signal kit and I had the lights out back in the early summer. When I put the lights back in the wire must have pressed against something and it rubbed it bare. What luck, but glad we found it.

[EMAS]

Yup you need to be careful with re-installing the tail lights. Shortly after I got mine the brake light (and then TS) fuse blew. After a little searching I found that at some point, whether at the factory or during a bulb replacement, the wires had been pinched by the mounting stud and eventually the insulation failed causing a short to ground and the fuse(s) to blow.

[Baconbit]

Yup exactly what happened to me.