View Full Version : Factory Sub Replacement Kenwood Kfc-w1705 Not Avalable?
SILVERMARAUDER
03-22-2004, 07:46 AM
Any ideas on where to get a somewhat direct bolt in sub i hear kenwood is no longer avalable that was the one i really wanted and does anyone remember the link for the sub vent part# and where to get it want to do that at same time thanks! :depress:
DONP1217
03-22-2004, 10:55 AM
Sounds like a good opportunity for upgrading to a new box, woofer, and amp.
SILVERMARAUDER
03-22-2004, 11:54 AM
Sounds like a good opportunity for upgrading to a new box, woofer, and amp.
no really want to keep stock look. any ideas on that?
rookie1
03-22-2004, 01:32 PM
RFP4406 (Rockford Fosgate 6-3/4" sub) found this one in another thread for you.
DONP1217
03-22-2004, 02:27 PM
You should be able to go with the Rockford Fosgate 6.5 inch woofer but I believe you'll need to stick with the stock amp if you want to keep the stock head unit becuase it uses a special wiring harness.
rookie1
03-22-2004, 02:58 PM
Harness isn't that special here's the breakdown:
Brown / Orange to Green = TX (pre-amp positive or signal?) by Bob's book
Red / Black to Black = RX (pre-amp negative or reference?) by Bob's book
Green / Violet (Bob's) or White / Violet (mine) to White = remote 7.4VDC "on"
Black / Green to 2 Reds = Ground to lug attached in the car behind the back seat
Red / Yellow to 2 Yellows = Battery 12.8VDC always hot unless fuse gone
SILVERMARAUDER
03-22-2004, 05:50 PM
thanks guys do you think Cruchfield will have it? will try it! ang still looking for the vent tube shomeone posted one on another trend had a part# and info to get it looking for that! :rock:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.