My Car's Dyno Results

[Donny Carlson]

Two weeks ago I had 4:10's, underdrive pulleys, and an SCT chip installed and tuned by Aric at Team Ford. I didn't bring my printout home that day, but this weekend Aric printed it out for me. I'll post them in the gallery since resizing them to fit here will likely make them hard to read.

There was no pull done to see what the car rated before any mods, unfortunately. After Scott changed the gears and installed the underdrive pulleys, Aric did a base line pull that showed SAE Horsepower of 241.7, SAE Torque of 262.5. After tuning, the pull showed 263.1 SAE Horsepower, 284.4 SAE Torque. It's interesting to look at the horsepower graphs to see how the factory EEC settings has a definite dip at about 54 MPH, and how the rev limiter kicks in.

http://www.mercurygallery.net/mmnet/watermark.php?file=500/1136DSC00465.JPG

[BillyGman]

LOL......54"MPH"??? I'm sure that you meant 5400 RPM's, right? Anyway, your dealer has a Dyno? I should move to your homestate if that's how dealers are over there. You sure won't ever find any Dyno in any dealer around here in Connecticut.......

[Bigdogjim]

Team Ford is a "total" Dealer:)

[BillyGman]

Well then I must say that it's definately unfortunate to have had dealings w/those "partial" or "incomplete" dealers.......

[Donny Carlson]

LOL......54"MPH"??? I'm sure that you meant 5400 RPM's, right? Anyway, your dealer has a Dyno? I should move to your homestate if that's how dealers are over there. You sure won't ever find any Dyno in any dealer around here in Connecticut.......
Sorry, but I was looking at the chart that has SAE Horsepower on the left side, Speed (MPH) along the bottom. It shows a dip in horsepower at 54 MPH (which corresponds to 2700 RPM on the other chart), and a dip in Torque also at this RPM. See below.

Yes, Team has a dyno, rated up to 1500 HP! It's a great dealership!

http://www.mercurygallery.net/mmnet/watermark.php?file=500/1136DSC00464.JPG