Radio Stuck
I have the radio removal wire inserts from a friend who just installed a new radio, and the right side comes loose, but not the left. In one of the left holes (the top) a short section of pot metal rod got broken off down in there. I had three pieces of brazing rod but not a fourth, so used a piece of rod that broke off, not my finest thought. I figure 1” is down in there. I get the wire insert all the way down, but it won’t free the left side. Any ideas? The old radio is junk, I don’t care if it gets wrecked but have to get it out. Q: with the right side loose is there something I can wedge down the left side to free it up?
Sent from my iPhone using Tapatalk
2003 black pre-decontented 300B #5886 of 7838; Born on 10/31/02
MartyO tune, 4:10's, T/A stud & girdle, MMX shaft+DS loop, Metco control arms, Quickor RSB, Addco FSB, Megs delete tips, Granatelli solid coil connectors, NGK plugs & LP 170 stat, DR rear engine cooling mod, PI 3000 TC, Level II tranny, Art Carr deep pan, Steeda pullies/billet caps, billet door locks, Ford Racing oil cap / polished coil covers, PHP CAK & Metco carbon fiber intake, DG Motorsports CF radiator cover, Fumoto oil drain valve, oil deflector, real Autometer gauges, ScanGauge II, Weatherflectors, underbody lighting kit, Zack chrome grill, OEM spoiler & door edge guards, KB dead pedal, Dynopro aluminum sills & pedals, Viper alarm w/ remote start, MM fender badges, red painted calipers, SS inserts, Silverstar Ultras, hood bumpers, 35% tints, Gorilla lug nuts, MM valve caps, Pro-Guard, DD trunk lid liner, CM UHI kit, CM Godshead rear & steering wheel badges, S-55 badge, FilterMag, MM trunk bib, ported sub-woofer.