Ride 1: 2003 300-A MM, black (naturally), K&N cold air, Granitelli Racing coils, Kybe shocks, Autometer "real" oil pressure and voltmeter, 14 inch front rotors and stainless lines from TCE with 6-piston Wilwood calipers and Hawk HPS pads, cryo-treated slotted rear rotors with TCE stainless lines and Hawk HPS pads, tune by Lidio, LED headlamps. Coming Soon: LED foglights, 200 Amp Alternator.
Ride 2: 2001 Kenny Brown "Panther 2" Crown Victoria, Black. K&N cold air intake to Allen Engine Development supercharger system with water-to-air intercooled Eaton MP-90 at 8 pounds. Extensive chassis bracing, Brembo 4-piston front calipers on 13 inch rotors with stainless lines. Trunk-relocated Optima Red-Top. 5000K Bi-Xenon HID's. And much, much more.
Check out your Ford dealer for Part # W704021S304M, Come in a pkg of 4 $4.24 Retail. It should be the same part but with some difference in the finish. Hope that helps.
Last edited by Toronto46; 03-22-2017 at 08:36 PM. Reason: errors
No Marauder
Got them, thanks!
Sent from my SM-G935T using Tapatalk
Ride 1: 2003 300-A MM, black (naturally), K&N cold air, Granitelli Racing coils, Kybe shocks, Autometer "real" oil pressure and voltmeter, 14 inch front rotors and stainless lines from TCE with 6-piston Wilwood calipers and Hawk HPS pads, cryo-treated slotted rear rotors with TCE stainless lines and Hawk HPS pads, tune by Lidio, LED headlamps. Coming Soon: LED foglights, 200 Amp Alternator.
Ride 2: 2001 Kenny Brown "Panther 2" Crown Victoria, Black. K&N cold air intake to Allen Engine Development supercharger system with water-to-air intercooled Eaton MP-90 at 8 pounds. Extensive chassis bracing, Brembo 4-piston front calipers on 13 inch rotors with stainless lines. Trunk-relocated Optima Red-Top. 5000K Bi-Xenon HID's. And much, much more.
The ones from Amazon are not exactly like the OEM ones but in my opinion the OEM ones were too wide and held on so strong that they often popped off and were lost when removing the gauge pod!!
The Amazon ones are a bit narrower and should snap in and out of place easier......you can also expand them if too loose too!!
No Marauder
They will hold the gauge pod in place so I guess they will work quite well!!
No Marauder
I got my Amazon ones. Will report back when I get my car out of storage.
Stumbled upon these.
Sent from my iPhone using Tapatalk Pro
I wish I'd have found this thread earlier. I'll add the ones I ended up buying to the thread, just for completeness, and in case the Ford part becomes unavailable or something. A bit pricier, but the listed price is for two. The clips I received were bright silver color, not matte, if that matters.
https://lmr.com/item/LRS-14527AHDW/9...l-Insert-Clips
There are currently 1 users browsing this thread. (0 members and 1 guests)