2014 Eaton Swap Thread Pics and Future Questions

[tbone]

Started the swap today. My goal was to get it to the point of the valve covers and front cover removed, radiator and cooler removed and get the valve covers ready for paint. Didn't quite get the valve covers ready for paint, but did stop by a local shop and had the alternator pulley swapped out and bought a new radiator. The one I got cheap on ebay was the wrong one.

Anyway, the engine is fabulous on the inside. No sludge, hardly any signs of wear, even the timing chain guides look perfect with 145k miles. I'm changing them anyway, since I already have the parts. Work 9-9 tomorrow which sucks. Next chance Thursday evening to proceed.
Cooling mod and guides/tensioners next.

In the third pic you can see a little slack in the chain on the left side. Right side is perfectly taught. Normal?

[tbone]

I should have flipped the pics before posting.

Thanks Justbob for the engine hoist trick to get the valve cover off.

[tbone]

Lots of room to work with no radiator in the way.

(The pics are flipped right on my cpu. They download wrong.)

[ChiTownMaraud3r]

Looking good so far. Best of luck with it.

[tbone]

Thanks man. Glad you got your car fixed!!!!

[ChiTownMaraud3r]

Thanks, yeah let me know if you need any reference pics as you go.

[tbone]

Did you do the crossover mod or the On3 delete kit? I'm doing the On3 and don't have a great grasp on how it all works and how much of the hose maze that comes from Ford remains.......

[8UWITH6]

Can you do guides and tensioners without removing the chains? LMK


Good luck with your swap sir. Post lots of pics please! Subscribed!

[ChiTownMaraud3r]

I used the On3 delete kit. Yeah it seems ambiguous to set up, I don't think they have instructions included. I also purchased pre-sized and ready to go stainless hoses to go with it thanks to member Chief on here. You need to use an aluminum pipe down by the radiator hose, here's the pic that I went off of, and my car looks the same. I can take pics of my actual setup tomorrow for you.

[tbone]

I could use as many pics as possible on this one.....thx

Where did you get the pipe?

[loud2004marquis]

Good luck with it and keep us updated!

[ChiTownMaraud3r]

I could use as many pics as possible on this one.....thx

Where did you get the pipe?

http://www.treadstoneperformance.com...rcooler+Piping


It's the 1.5" 70* pipe, sku number AP15070.

[tbone]

Thanks Chitown!

Now I understand why a lot of the lower hose plumbing is deleted.

[sflrainmaker01]

Dude, looks great so far! Good luck! I will be following your thread and build! Keep the pics coming!

[justbob]

Your pointing to the right chain, and yes depending on cam rotation it is either loose or tight. Spin the motor by hand and watch it slap around.


Self proclaimed Builder Of Badassery.

Buy it, Break it, Build it BETTER.
"Since 2004"