Silverback
Serpentine belt for supercharger application
I need a little help. My serpentine belt shredded on my MM while idling in the parking lot and I need a part number.
My MM is equipped with a NOVI 1200 supercharger. I wrote the part number and length down years ago and stored the info in my tool box. Well it's no longer there and the torn belt yields no info.
Zack replaced the belt some years ago, April 2012.
Can anyone tell me how to measure for a replacement belt.
Regards,
Pat
Last edited by Pat; 03-29-2019 at 12:02 PM.
I'm Your Huckleberry
Most likely its 108" long. 6 or 8 rib. Also check all pulleys and belt alignment. There's a reason the belt shredded.
You "feel" the difference because you want to "feel" the difference. Since you just spent money on the upgrade you "have" to feel the difference
I'm looking to eliminate the double pump process I have to follow right now to get the pedal hard
2004 300A Procharger #0010 D1X
2003 300A Procharger #0017 D1SC (SOLD. Last I heard, it was in Washington State)
Turbo Marauder
Probably a 1095
the grundle always gets ya
The one that came with my kit I think was 110.5. Gator back 4061105. That’s for the stock pulley. I have a smaller pulley now and no longer have that belt to be sure.
300A Black
4:10 gears, Flowmaster 44's with rear cat delete, SW headers with 3 inch cats to 2.5 custom h. 3500 stall, Twisted synergy dyno tune, addco f/r , rear control arms, Novi 1200 air to air with the fixings.
Silverback
cleared out the old belt debris and checked the pully's, all spin freely, I'll replace a couple due to bearing noise.
Most of the old belt was bound up on the small pullys's behind the supercharger.
Now to measure for the new belt. I'll tape string around the path of the belt to see how many inches it is and compare to what you guys posted.
Turbo Marauder
Just get the 1095
Silverback
OK 1095 it is.
Silverback
I did find a frozen pully, the one with ribs. That's what I think shredded the belt, draging the belt over the "sharp" ribs.
Got all the parts, disassembly, cleaning and reassembly in progress.
Silverback
Ordered new bottles of S/C fluid from Paxton. All cleaned up, will fit the new belt after I change the fluid.
Regards
Silverback
Well the S/C fluid finaliy came in, changed the fluid in the S/C and put on the new belt. Took several trips to NAPA but got a belt that fits. Gates 25-061110, the belt is
111 7/8" long.
car runs much quieter with the new pully's. 146K on the trip meter.
Jason, my Honda mech, did all the work. I just kibitzed from my chair.
Pat
Turbo Marauder
I don't think that's the correct belt!!!!!!!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote