Originally Posted by
montyd
well i have a grand and counting into fixing my heads right now. just had to put all new exhuast guides, 1 new exhuast valve since it was burnt, have them cleaned because they were FULL of carbon. my exhuast ports had over 1/16th of an inch of carbon built up on them. i keep telling myself it was worth it just to put new valve seals in it so it doesnt smoke on start up any more. haha but i do want to do this mod while i have it apart. just to make sure my time and money wasnt to waste over a couple hundred bucks worth of security.
You have a $1,000 into repairing heads? What all have they done?? I just had a valve job done on mine and they installed all new Manley valves, Crower cams, and heavy duty springs for $550! I obviously supplied all parts.
Self proclaimed Builder Of Badassery.
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.