I'm replacing my evaporator core, receiver/dryer, and orfice tube. Not touching the compressor because it is still good, just a leak in the core. How much pag oil (if any) would you recommend adding?
Sent from my XT1031 using Tapatalk
I'm replacing my evaporator core, receiver/dryer, and orfice tube. Not touching the compressor because it is still good, just a leak in the core. How much pag oil (if any) would you recommend adding?
Sent from my XT1031 using Tapatalk
Last edited by grandepau00; 04-20-2014 at 09:23 AM.
None to extremely little.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
Thanks guys.
Sent from my XT1031 using Tapatalk
Found this online:
If simply replacing an A/C component, use this as a guideline for oil replacement:
Component Amount Of Lubricant To Add
Accumulator 2 oz.
Condenser 1 oz.
Evaporator 2 oz.
Filter Drier 1 oz.
The Blackbird
Trilogy #61
Driveway Queen
The Spruce Goose
2004 Grand Marquis LS Limited Edition
Daily Driver
I recgarged my a/c 3 years ago. Blew warm the other day. Pushed on the relief valve and it had pressure. Emptied it completely, only air came out. Added 38 oz of refrigerant and it blows ice cold. Not sure why it needed another recharge but still had pressure. Did not add any pag oil.
There are currently 1 users browsing this thread. (0 members and 1 guests)